Identifying open end points

ToolBox automatically identifies and shows open end points

After uploading the drawing, ToolBox will automatically detect any entities which have open endpoints. The issue can be viewed by clicking the warning icon. Some open endpoints may be acceptable for quoting purposes, if unacceptable the drawing must be corrected in a CAD program and re-uploaded to ToolBox:

An uploaded drawing showing an open end point.

To view the issue for evaluation, we recommend opening Drawing Doctor.

SHOW ENDPOINTS UN-ticked.

In the toolbar, across the top of the drawing page, there is a setting to switch the visualisation on/off, the is on by default. To turn it off, un-tick the checkbox:

To turn it on, slide it to the right:

SHOW ENDPOINTS switched ON.

The opening is then shown on screen:

The end points are highlighted and are pulsing.

Last updated